|
We are pleased to announce the appointment of another new Agent, this time in Russia.
Based in St. Petersburg, 'Unit Service' are very active in Russia, Ukraine, Belarus and other CIS countries.
We are delighted to welcome them to our sales team and look forward to exhibiting with them at Rosupack 2013.
|
|
Our conviction in S-Press pays dividends |
|
A recent S-PRESS installation at the company IBO Ondulati in Italy has proved a great success.
IBO run a modern 2800mm wide MHI Corrugator. However, they could not run their heavy-weight double-wall grades at the speeds they required. With the board grade K275/S135/T130/S135/K275 the maximum speed achievable was 190 m/min.
Upon investigation, it was discovered the problem lay with the poor performance of the existing Double Facer Heat Transfer system. We were confident enough to offer a guarantee that S-PRESS would run in excess of 235 m/minin and therefore an order was placed.
Almost immediately following the installation of the S-PRESS, the customer was able to increase the maximum speed for this board grade from 190 m/min to 265 m/min and at the same time reduce the Double Facer power consumption by 20% confirming S-PRESS as the best performing and efficient system in the World today.
|
|
|
CCE 2013 exhibition in Munich |
|
SIMON is pleased to report a highly successful appearance at the CCE 2013 exhibition in Munich where we exhibited the S-PRESS Double Facer Heat Transfer System.
A great deal of interest was shown in the S-PRESS with many positive enquiries being received.
|
|
Another very successful S-PRESS installation at a Saica plant in Spain..
Immediate improvements were faster speeds, improved quality, flatter board and a reduction in Double Facer power consumption.
|
|
New Agents for Spain, Portugal and Italy |
|
We are excited to announce the appointment of two new Agents :.
Javier Irurtia, representing Spain and Portugal, and Giuseppe (Pino) Maricchiolo, representing Italy, both bring with them a great wealth of experience and knoweledge that has already lead to S-PRESS sales in their territories.
We welcome them both to our sales team.
|
|
Another S-Press success in Italy |
|
We recently installed a S-PRESS retrofit at the company S.I.F.A., situated in central Italy and owned by the Trasarti brothers.
S.I.F.A. made the decision to decommission their existing shoe-type heat transfer system and replace it with S-PRESS. This important decision was made with the expectation of eliminating constant down-warp problems when running E-flute at speeds of 250 m/min.
Following the first two weeks after the installation, the customer was particularly pleased not only because the down-warp problem was resolved, but the S-PRESS had also given even more benefits, including:
- Flatter, drier board
- Reduced glue consumption, i.e. 1 gsm/m2 reduction
- Reduced main drive power consumption of between 30kW - 40kW
- Increase in double-wall speeds to 250 m/min
- Increase in E-flute speeds up to 300 m/min
- Elimination of edge-bond problems on all 7 paper widths.
|
|
|
|
|
|
